Repair Equipment Used For Stamping Dies?

Categories

New Products

Carbide Hexagonal Dies Established in 1999, Zhu Xun Precision Mold and Die Factory meets customers’ rapid and large demand with its profound knowledge of tungsten carbide, lates... more
Industrial Carbide Wear Parts 2 Established in 1999, Zhu Xun Precision Mold and Die Factory meets customers’ rapid and large demand with its profound knowledge of tungsten carbide, lates... more
Carbide Shelling Molding Dies Established in 1999, Zhu Xun Precision Mold and Die Factory meets customers’ rapid and large demand with its profound knowledge of tungsten carbide, lates... more
Carbide Shrink Tube Mould Established in 1999, Zhu Xun Precision Mold and Die Factory meets customers’ rapid and large demand with its profound knowledge of tungsten carbide, lates... more
High Precision Tungsten Carbide Shaped Dies Established in 1999, Zhu Xun Precision Mold and Die Factory meets customers’ rapid and large demand with its profound knowledge of tungsten carbide, lates... more

Repair Equipment Used For Stamping Dies?

2024-06-16

All parts of stamping die must pass through these procedures first.

First of all, we need to open the material. How do we proceed with the next step without opening the material? Open the material, that is rough machining. Generally, a template must be roughly planed by a planer, then roughed and roughed by a large water grinder (grinder, also known as a large grinder), leaving a certain margin (generally 50 margins, precision requirements plus or minus 10 on it), and then take heat treatment to heat treatment, after heat treatment, after passing through Large grinder finishing, this time the accuracy of a higher requirement, such as the template thickness is 25.00 mm, then the accuracy requirements must be within 0.01 mm plus or minus. Look at the role of the template, generally one or two have little to do with, as long as the product does not have a mold impression.

After finishing the grinding machine, send it to the hole, then line it, then the milling machine, CNC and so on.

If it's a small part, it's like this: according to the size of the part, with a sawing machine, or milling machine, grinding after roughing, cutting off the excess slices, make it almost depend on the situation either to wire cutting, or to CNC (also known as high-speed milling machine) processing, need to discharge on the discharge point. After the completion of the product warranty survey.

Previous :
How Is The Stamping Die Processed Step By Step?
Next :
What Are The Characteristics Of Stamping Process?