• 2024-06-17 18:36:59

As one of the usual metal stamping defects, the causes of chipping are various, some of which are due to poor mold design, some are due to poor materials, and s...

• 2024-06-17 18:35:37

Compared with ordinary stamping, the speed of high-speed stamping is several hundred times per minute to thousands of times, so the production efficiency is muc...

• 2024-06-17 18:33:53

Simple and intuitive stamping principle dynamic diagram Simple deep drawing process Circular workpiece bending Pendulum block bending Double pendulum bloc...

• 2024-06-17 18:32:58

Metal stamping parts are formed by stamping process of metal stamping process and die, stamping equipment and stamping materials. The advantages of metal stampi...

• 2024-06-17 18:31:31

All parts of stamping die must pass through these procedures first.

First of all, we need to open the material. How do we proceed with the next step without op...

• 2024-06-17 18:29:19

In either process, we always hope that the total height of the nitrogen springs should not be too high to avoid instability and too complex to install on the mo...

• 2024-06-17 18:27:53

All parts of stamping die must pass through these procedures first.

First of all, we need to open the material. How do we proceed with the next step without op...

• 2024-06-17 18:27:17

First, why the mold needs to be repaired:

1. Everyone has heard of the story of water-dropping stone. Because the mold is in motion during mass production, and...

• 2024-06-17 18:26:13

According to the standard, stamping elbows can be divided into: national standard stamping elbows, non-standard stamping elbows, international standards: German...

• 2024-06-17 08:52:34

Material and selection for stampingThe properties of the materials used in stamping are closely related to the stamping production, which directly affect the st...